Function esp_idf_sys::uart_enable_pattern_det_baud_intr

pub unsafe extern "C" fn uart_enable_pattern_det_baud_intr(
    uart_num: uart_port_t,
    pattern_chr: c_char,
    chr_num: u8,
    chr_tout: c_int,
    post_idle: c_int,
    pre_idle: c_int,
) -> esp_err_t

@brief UART enable pattern detect function. Designed for applications like ‘AT commands’. When the hardware detect a series of one same character, the interrupt will be triggered.

@param uart_num UART port number. @param pattern_chr character of the pattern. @param chr_num number of the character, 8bit value. @param chr_tout timeout of the interval between each pattern characters, 16bit value, unit is the baud-rate cycle you configured. When the duration is more than this value, it will not take this data as at_cmd char. @param post_idle idle time after the last pattern character, 16bit value, unit is the baud-rate cycle you configured. When the duration is less than this value, it will not take the previous data as the last at_cmd char @param pre_idle idle time before the first pattern character, 16bit value, unit is the baud-rate cycle you configured. When the duration is less than this value, it will not take this data as the first at_cmd char.

@return - ESP_OK Success - ESP_FAIL Parameter error